Re: dziwna sprawa z wykrywaniem sieciówek

Thread View: alt.pl.comp.os.linux.debian

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by jacek Fri, 28 Sep 2007 13:28

#29346

Author: jacek
Date: Fri, 28 Sep 2007 13:28

54 lines
3721 bytes

Dnia Fri, 28 Sep 2007 14:27:47 +0200, kanold napisał(a):

> zobacz sobie do /etc/udev/rules.d/z25_persistent-net.rules

Wybacz, ale twoja odpowiedź nie jest na żadne z moich pytań. Dodatkowo
generuje pytania:
1. Po co (pytanie o cel): This file was automatically generated by the
/lib/udev/write_net_rules program, probably run by the
persistent-net-generator.rules rules file. 
2. Co (jaki program) korzysta z
zawartych tu danych? Czy polecenie ifconfig, które podaje dokładnie takie
same dane, z tym samym błędem dot. karty wifi, polegającym na złym
odczycie MAC-a tej karty? (z windy wiem ze MAC tej karty to ....2F-5A a
jak widać w tym pliku oraz w ifconfig jest to ......00-00)

Na wszelki wypadek podaję to co wygrzebałem w sysconfig i dmesg na temat
sieciówek, może będzie pomocne w analizie:

SYSLOG
Sep 11 14:10:33 net/hw-detect.hotplug: Detected hotpluggable network interface eth0
Sep 11 14:10:33 net/hw-detect.hotplug: Detected hotpluggable network interface eth1
Sep 11 14:10:33 net/hw-detect.hotplug: Detected hotpluggable network interface eth2
Sep 11 14:10:33 net/hw-detect.hotplug: Detected hotpluggable network interface lo
Sep 11 14:10:34 main-menu[1344]: INFO: Menu item 'netcfg' selected 
Sep 11 14:10:34 kernel: eth0: resetting device...
Sep 11 14:10:34 kernel: eth0: uploading firmware...
Sep 11 14:10:34 kernel: prism54: request_firmware() failed for 'isl3890'
Sep 11 14:10:34 kernel: eth0: could not upload firmware ('isl3890')
Sep 11 14:10:34 kernel: eth0: islpci_reset: failure
Sep 11 14:10:34 netcfg[8659]: INFO: ethtool ioctl on eth0 failed  
Sep 11 14:10:34 netcfg[8659]: WARNING **: couldn't determine MII ioctl to use for eth0  
Sep 11 14:10:35 netcfg[8659]: INFO: eth0 is not associated. Relegating to defwireless 
Sep 11 14:10:35 netcfg[8659]: INFO: ethtool ioctl on eth1 failed  
Sep 11 14:10:35 netcfg[8659]: INFO: eth1 is disconnected. (MII)  
Sep 11 14:10:35 netcfg[8659]: INFO: eth1 is not a wireless interface. Continuing. 
Sep 11 14:10:35 kernel: 0000:01:0a.0: tulip_stop_rxtx() failed
Sep 11 14:10:35 kernel: eth2: link up, 100Mbps, full-duplex, lpa 0x45E1
Sep 11 14:10:35 netcfg[8659]: INFO: eth2 is connected.  


DMESG
eth0: ADMtek Comet rev 17 at 00019000, 00:0C:F6:0E:C3:87, IRQ 193.
8139cp 0000:01:0b.0: This (id 10ec:8139 rev 10) is not an 8139C+ compatible chip
8139cp 0000:01:0b.0: Try the "8139too" driver instead.
8139too Fast Ethernet driver 0.9.27
ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
ACPI: PCI Interrupt 0000:01:0b.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 201
eth1: RealTek RTL8139 at 0x9400, 00:0f:ea:be:b7:07, IRQ 201
eth1:  Identified 8139 chip type 'RTL-8100B/8139D'
[-]
eth2: link up, 100Mbps, full-duplex, lpa 0x45E1
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads