🚀 go-pugleaf

could any take another stab at this one please:

I boot off this disk that DID already work on this same machine
(I've already used this same disk to instal and get going a min
instal [bin & manpages] on this same machine), but now it won't
let me.  Now, it only allows me to boot up so far
as the "Kernel Configuration Menu" (3 choices), and then down into
the (2nd choice) "Start kernel configuration in full-screen visual
mode", after which, making the 2nd choice, I am allowed to go an choose my
active devices (alt x for exapanding, and all that). Upon quitting
and saving (or not, made no differnce) I get the following error message:

fatal trap 12: page fault while in kernel mode
fault virtural address  = 0x4
fault code              = supervisor read, page not present
instruction pointer     = 0x8:0f017e322
stack pointer           = 0x10:0xefbffd44
frame pointer           = 0x10:0xefbffd64
code segment:           = base 0x0, limit 0xfffff, type 0x1b
                        = DPL 0, pres 1, def32 1, gran 1
processor eflags        = interrupt enabled, resume, IOPL = 0
current process         = 0 ()
interrupt mask          = net tty bio
panic: page fault
Automatic reboot in 15 seconds - press a key on the console to abort

..... at which point I'm yelling  "H  E  L  P  !"
this is what i'm using:

Computer:  Compaq XL466
-----------------------------------------------------------------
Compaq BIOS reports (most recent 97/07/04 rompaq):
--------------------------
Compaq DESKPRO XL processor board:  486 DX2 66MHz
2 PCI slots  5 EISA slots
RAM:  16MB = 2x4MB + 8MB (onboard)
COM1, COM2, LPT1, pointing device interrupt endable
Integrated audio:  enabled 530h-537h
Integrated diskette controller:  enabled 3.5" floppy
Integrated IDE controller:  disabled
Integrated PCI Ethernet controller:  enabled
	port:  7000h-701fh
	IRQ 11
Integrated SCSI BIOS:  enabled
Integrated PCI SCSI-2 controller:  enabled
	port:  7100h-717fh
	IRQ 15
SCSI 0:  Seagate ST1480N 426 MB
SCSI 1:  HP C2234-300 328 MB
PCI video card:  Compaq Qvision 2000 graphics controller
-----------------------------------------------------------------------
Win95 hardware config reports:
---------------------
AMD PCNET Family Ethernet adapter (PCI%ISA) --> for my integrated
controller
AMD PCI SCSI controller --> for my integrated controller
Matrox MGA Ultima/Impression PCI --> for my video card


right now:  win95 and bsd install files on first boot disk SCSI 0 (Seagate)
                SCSI 1 is DOS formatted and waiting to be taken to bsd
land....


Ouch !

thanks from maris

mmalic@netrover.com