🚀 go-pugleaf

Tue, 14 Feb 2006 23:12:09 +0100, na pl.comp.networking, piotrek napisal(a):

> dlaczego wszedzie podane jes ze ma byc protocol pppoe??

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hvpdn_r/vpd_h.pdf

Ja znajduje takie przyklady:

The following example enables the tunnel server to accept Layer 2
Forwarding (L2F) tunnels from a NAS named router23. A virtual-access
interface will be cloned from virtual-template 1. 

Router(config)# vpdn-group 1
Router(config-vpdn)# accept-dialin
Router(config-vpdn-acc-in)# protocol l2f
Router(config-vpdn-acc-in)# virtual-template 1
Router(config-vpdn)# terminate-from hostname router23
__________________________

The following example configures the router so that tunnels requested by
the NAS named router16 are created with the tunnel attributes specified by
VPDN group 1, while any other incoming L2TP tunnel request will use the
settings configured in the default VPDN group, VPDN group 2: 

Router(config)# vpdn-group 1
Router(config-vpdn)# accept-dialin
Router(config-vpdn-acc-in)# protocol l2tp
Router(config-vpdn-acc-in)# virtual-template 2
!
Router(config-vpdn)# terminate-from hostname router16
Router(config)# vpdn-group 2
! Default L2TP VPDN group
Router(config-vpdn)# accept-dialin
Router(config-vpdn-acc-in)# protocol l2tp
Router(config-vpdn-acc-in)# virtual-template 3
__________________________

The following example configures a VPDN group on the NAS to accept L2TP
tunnels for dial-out calls from the tunnel server TS23 using dialer 2 as
its dialing resource: 

Router(config)# vpdn-group 1
Router(config-vpdn)# accept-dialout
Router(config-vpdn-acc-ou)# protocol l2tp
Router(config-vpdn-acc-ou)# dialer 2
!
Router(config-vpdn)# terminate-from hostname TS23
!
Router(config)# interface Dialer2
Router(config-if)# ip unnumbered Ethernet0
Router(config-if)# encapsulation ppp
Router(config-if)# dialer in-band
Router(config-if)# dialer aaa
Router(config-if)# dialer-group 1
Router(config-if)# ppp authentication chap

....

Kyniu