SolidEdge - grubośc linii na rysunkach plaskich - Thread - go-pugleaf

Thread View: pl.comp.cad

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Adampio Fri, 07 Aug 2009 10:59

SolidEdge - grubośc linii na rysunkach plaskich

#53049

Author: Adampio
Date: Fri, 07 Aug 2009 10:59

9 lines
1026 bytes

W SE jest mozliwośc generowania tzw. rysunkow. Niestety za malo znam ten 
program zeby kontrolowac grubosc linii i linia gruba (konturowa) na 
formacie A4 wychodz mi okolo 0.3 mm :-(
Ma ktos pomysl co jak te grubosci zwiekszyc? Tak do 0,6-0,7mm (SE v17, 
akademicka, polskojezyczna)

PZDR

Adampio

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads