🚀 go-pugleaf

> 1. Odpali�em system
> 2. U mnie automatycznie �aduje si� KDE
> 3. Odnalaz�em folder zawieraj�cy rpm'a z instalk� Kadu
> 4. Mlask Mlask
> 5. Zainstalowa�o si� - cho� wcale nie krzycza�, �e to zrobi�
> 6. Mlask Mlask na domek - katalog domowy - otwiera si� okienko z moimi
> rzeczami
> 7. strza�eczka do samej gury (katalog root'a)
> 8. wyszukaj *kadu* - znalaz� instalk�, jakie� biblioteki i kadu.exe
> 9. Podobnie jak w windzie stworzy�em skr�t do Kadu.exe na moim pulpicie


niestety nie dziala to w przypadku mp3blaster-3.1.3
robie tak: rozpakowuje, wrzucam wszystko do forlderu Documants
i klikam wszystkie piliki po kolei (tak lopatologicznie :)
niestety instalacja nie nastepuje, a z read'a niewiele rozumiem

oto co napisali w podpunkcie installation ( moze ktos przetlumaczy :)

3. Installation

-------------------------

If you're eager to start, this will do:

./configure

make

make install

Run './configure --help' to get a list of compile-time options.

There are a few important options that can have an impact on the

quality of audio-playback and CPU usage on your system. These are:

--enable-newthreads (auto-enables --with-pth)

This will use an alternative playback buffering system. It

might work better than the conventional buffering system on many

systems. Please give it a try if you're experiencing skips

during sound playback. Mail problems / successes.

--with-pth (without --enable-newthreads)

Uses libpth instead of the OS-specific pthreads implementation.

This might reduce CPU-overhead and improve sound playback.

Please try this and reports problems / successes.

If you don't supply any of the above mentioned flags, the

OS-specific pthreads implementation will be used, with default

buffering mechanism. On FreeBSD no buffering will be used by default

since it will probably hog your CPU or simply hang. using libpth on

Free(/Net/Open)BSD is therefor recommended.