🚀 go-pugleaf

Witam.

Mam w systemie włączone wszystkie wymagane moduły do obsługi drukarki:
usb-uhci, usbcore, printer. Zainstalowałem apsfilter, skonfigurowałem (aps1), dodałem wpis w fstab:
none            /proc/bus/usb   usbdevfs        defaults        0       0
Dalej zrobiłem export PRINTER="aps1".

tux:/home/konrad# dmesg |grep -i usb
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 10:29:43 Apr 14 2002
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 5
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
hub.c: USB new device connect on bus3/1, assigned device number 2
usb.c: USB device 2 (vend/prod 0x3f0/0x2004) is not claimed by any active driver.
usb.c: registered new driver usblp
printer.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 1
printer.c: v0.8:USB Printer Device Class driver
usb.c: USB disconnect on device 2
printer.c: usblp0: removed
hub.c: USB new device connect on bus3/2, assigned device number 3
printer.c: usblp0: USB Bidirectional printer dev 3 if 0 alt 1
usb.c: USB disconnect on device 3
printer.c: usblp0: removed
hub.c: USB new device connect on bus3/1, assigned device number 4
printer.c: usblp0: USB Bidirectional printer dev 4 if 0 alt 1
usb.c: USB disconnect on device 4
printer.c: usblp0: removed

Mimo tych ustawień nie mogę drukować ani w OO, ani w Abiword ani w innych edytorach.

Co mam jeszcze zrobić, żeby drukarka działała?

Z góry dzięki za odpowiedź.

-- 
pozdrawiam, Konrad
LRU #293048