🚀 go-pugleaf

It sort of works now...
Q3 will only run in a window with TV_out,not full screen.If I try 
setting Q3 to run in a window that is the same size as the screen 
(window and res both on 800 X 600) the window is off center and I can't 
figure out how to move it since the cursor stays in the window.Any 
ideas? Thank you.

S.P. Goodman wrote:
> "Dave" <sneezeg...@netscape.net> wrote in message
> news:3E017EE6.2060302@netscape.net...
> 
>>Is there a way I can play Quake 3 using my TV as a monitor? I'm using a
>>G3 Mac with Q3 v1.3.2 and an original Radeon Mac Edition PCI card. It
>>gets as far as the "id" splashscreen,then the TV goes blank (but the
>>sound keeps going). It works fine on the monitor at the same resolution.
>>Any ideas?
>>Thank you.
> 
> 
> It might be an issue with what output resolution the TV out - I'm assuming
> it's a composite signal - supports.  In the past when I produced output for
> a TV from an old card, the ATI All-in-One (PC), it was limited to 800x600,
> and that was for SVHS at that.  Instead I produced at 640x480, and was able
> to see reasonably well on a TV set.  You might try checking the manual for
> the card you have to see what max resolution it'll support - or reload your
> drivers completely and see what happens.  Or reinstall Q3.
> 
> 
> --
> SP Goodman aka Spud Patrol!
> * http://www.earthlight.net
> 
>